Siemens SIMATIC Distributed I/O System DP/ASi Link Specifiche Scaricare il pdf (Pagina 151)

Maintenance

7-3

Distributed I/O Device ET 200M

EWA-4NEB780600602-06

7.2 Replacing the IM 153-1

Initial Situation

The IM 153-1 is installed. You want to install a new IM 153-1 of the same type.

Slot Numbering

If you have given slot numbers to the modules in your system, you must remove

the numbering from the old module when you replace the module and use it on the

new module.

Unplugging the Bus Connector

With a looped-through interconnecting cable you can unplug the bus connector

from the PROFIBUS-DP interface without interrupting data traffic on the network.

Note

A data communication error may occur on the network.

A network segment must always be terminated at both ends with the terminating

resistor. This is not the case, for example, if the power supply is not activated on

the last slave with a bus connector. The efficacy of the terminating resistor is

impaired because the terminating resistor in the bus connector gets its voltage

from the node.

Please make sure that power is always supplied to nodes

on which the terminating resistor is active.

Tip: You can use the PROFIBUS terminator as an active bus terminating element.

Removing a Module

To remove the module, proceed as follows:

1. Put the on/off switch of the power supply module in the 0 position ( :output

voltage 0 V).

2. Remove the bus connector.

3. Disconnect the wiring.

4. Remove the fixing screws of the IM 153-1.

5. Swing the IM 153-1 out.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 239 240

Nessun commento

Siemens SIMATIC Distributed I/O System DP/ASi Link Specifiche Pagina 151