Siemens SINUMERIK 802D sl Manuale dell'Operatore Scaricare il pdf (Pagina 214)

Overview of alarms 06/2009

Cycle alarms

2-214

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm display.

Remedy: Program a technology block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61203 [Channel %1: ] Block %2: No position cycle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No positioning cycle was programmed in the machining block.

Alarm triggered by following cycles: E_MANAGE, F_MANAGE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Program positioning block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61204 [Channel %1: ] Block %2: Technology cycle unknown

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified technology cycle in the machining block is unknown.

Alarm triggered by following cycles: E_MANAGE, F_MANAGE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Delete and reprogram the technology block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61205 [Channel %1: ] Block %2: Position cycle unknown

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified positioning cycle in the machining block is unknown.

Alarm triggered by following cycles: E_MANAGE, F_MANAGE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Delete and reprogram the positioning block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61210 [Channel %1: ] Block %2: Block search element not found

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The element specified for the block search does not exisit.

Alarm triggered by following cycles: E_MANAGE, E_PS_CIR, E_PS_MRX, E_PS_POL, E_PS_SEQ,

E_PS_XYA, F_MANAGE, F_PS_CIR, F_PS_MRX, F_PS_SEQ

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Repeat block search.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 339 340

Commenti su questo manuale

Nessun commento

Siemens SINUMERIK 802D sl Manuale dell'Operatore Pagina 214

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Siemens SINUMERIK 802D sl