Siemens SINUMERIK 802D sl Manuale dell'Operatore Scaricare il pdf (Pagina 199)

Cycle alarms

06/2009 Overview of alarms

2-199

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Interface signals are set.

Alarm display.

Remedy: Parameter SDIR (or SDR in CYCLE840) must be programmed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61103 [Channel %1: ] Block %2: Number of holes is zero

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No value for the number of holes has been programmed. Alarm triggered by following cycles:

HOLES1, HOLES2.

Remedy: Check parameter NUM.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61104 [Channel %1: ] Block %2: Contour violation of slots

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Incorrect parameterization of the milling pattern in the parameters which define the position of the

slots/elongated holes on the circle and their form. Alarm triggered by following cycles: SLOT1, SLOT2,

LONGHOLE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61105 [Channel %1: ] Block %2: Milling cutter radius too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The diameter of the cutter used is too large for the form to be machined. Alarm triggered by following

cycles: SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE, CYCLE90.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Either a tool with a smaller radius has to be used or the contour must be modified.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61106 [Channel %1: ] Block %2: Number of or distance between circular

elements

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Incorrect parameterization of NUM or INDA. The layout of the circle elements within a full circle is not

possible. Alarm triggered by following cycles: HOLES2, LONGHOLE, SLOT1, SLOT2.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Correct parameterization.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 339 340

Commenti su questo manuale

Nessun commento

Siemens SINUMERIK 802D sl Manuale dell'Operatore Pagina 199

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Siemens SINUMERIK 802D sl