Siemens SINUMERIK 802D sl Manuale dell'Operatore Scaricare il pdf (Pagina 202)

Overview of alarms 06/2009

Cycle alarms

2-202

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Interface signals are set.

Alarm display.

Remedy: Check parameter _LP1 or _LP2.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61117 [Channel %1: ] Block %2: Active tool radius <= 0

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The radius of the acive tool is negative or zero. Alarm triggered by following cycles: CYCLE71,

POCKET3, POCKET4.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61118 [Channel %1: ] Block %2: Length or width = 0

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The length or width of the milling area is illegal. Alarm triggered by following cycle: CYCLE71.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameters _LENG and _WID.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61119 [Channel %1: ] Block %2: Nominal or core diameter programmed

incorrectly

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The nominal or core diameter was incorrectly programmed. Alarm triggered by following cycles:

CYCLE70, E_MI_TR, F_MI_TR.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check thread geometry.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61120 [Channel %1: ] Block %2: Thread type inside / outside not defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The thread type (internal/external) was not defined. Alarm triggered by following cycles: CYCLE70.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The internal/external thread type must be entered.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 339 340

Commenti su questo manuale

Nessun commento

Siemens SINUMERIK 802D sl Manuale dell'Operatore Pagina 202

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Siemens SINUMERIK 802D sl