Siemens FIREFINDER-XLS Informazioni Techniche Scaricare il pdf (Pagina 5)

programmed usage. The label slides behind a clear

protective membrane. One of the LED's assigned to each

switch is a dual color LED used to indicate what type of

signal is active.

Each SCM-8 and each switch is fully programmable and

may be used to control speaker circuits, and awide range

of general system functions such as All Call, All Evac,

Warden's Page, Speaker, etc. Anynumber of circuits may

be grouped and controlled bya single switch. Switch

usages and zone groupings are assigned using the ZEUS

system programmingsoftware.The SCM-8s are mounted

on a hinged panel as a partof the FireFinder XLS Command

Console enclosure.

LCM-8 LED Control Module

The LCM-8 is an FireFinder XLS option module which

provides LED annunciation of system activity. Each LCM-

8 module contains eight groups of 2 LED's, each of which

can be assigned to desired outputs using the ZEUS

programming software. Eight LED's are dual color capable

of being lighted either RED or GREEN flashing or steady.

The remaining LED's are AMBER flashing or steady. A

space is provided for labeling of LED functions. The label

slides behind a clear protective membrane. The LCM-8

dimensions are identical to the SCM-8 and is mounted on

the same hinged panel as a part of the FireFinder XLS

Command Console enclosure.

FCM-6 Fan, Motor, dampers Control Module

The FCM-6 is an FireFinder XLS command console option

module that provides manual control of building HVAC

system fans, motors, and dampers. EachFCM-6 module

provides (6) sets of (3) push button switches for manual

system control. Each switch has3 associated LEDs to

LCM-8

FCM-6

indicate Fan/Damper/Motor status: OFF (Red LED), ON

(Green LED), TROUBLE(Yellow LED).

PSC-12 Power Supply Charger Module

The PSC-12 is a high current power supply that provides

the FireFinder-XLS primary regulated 24VDC power to

operate. It is rated at 12Amps (Alarm)/5Amps (Standby)

and has a built in battery charger capable of charging up to

100AH batteries. The PSC-12 is an addressable intelligent

microprocessor controlled module that communicates it

status to the system operator interface (PMI). The PMI is

able to query the status of the power supply to obtain

information regarding system charging current, terminal

loading information, ground fault conditions and more.

PSC-12 Power Supply Charger Module

PTB Power Termination Board

The PSC-12 comes packaged with a module called the

PTB. The PTB is the Power Termination Board and is

required for operation with the PSC-12. The PTB filters the

power from the incoming AC mains and distributes it to

the PSC-12 power supply and the optional PSX-12 power

supply extender.

The PTB has an optional connector that can be used during

system installation, commissioning & service to provide

the technician with a place to plug in their laptop computer

if required. The AC-ADPT is an optional accessory cable

that allows connection on one side to the PTB via a keyed

connector and on the other end directly into to the laptop's

transformer. Most laptop computer external power trans-

formers have removable AC power cords which can be

replaced by the AC-ADPT to temporarily provide an AC

power source for laptop computer used during system

installation, service and maintenance calls when needed.

PTB Power Termination Board

1 2 3 4 5 6 7 8 9 10 11 12

Commenti su questo manuale

Nessun commento

Siemens FIREFINDER-XLS Informazioni Techniche Pagina 5

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Siemens FIREFINDER-XLS