Siemens FIREFINDER-XLS Manuale di Avvio Rapido Scaricare il pdf (Pagina 2)

CAUTION

ALL WIRING MUST BE DONE AS DESCRIBED BELOW

TO OBTAIN SAFE AND PROPER SYSTEM OPERATION.

1. Earth ground the FireFinder-XLS enclosure properly; see the latest edition of the

National Electrical Code or CAN/ULC-S524-01 Canadian Electrical Code for

approved methods. Conduit ground is NOT adequate.

2. To wire the System in compliance with NEC Article 760, refer to the Power

Limited Wiring Instructions for the CAB1 Enclosure, P/N 315-033007, or the

CAB2-BB/CAB3-BB, P/N 315-033009, as applicable.

3. INSULATE ALL CABLE DRAIN WIRES from any conduit or earth grounded

electrical box, including those in the FireFinder-XLS enclosure.

4. Connect shield cable drain wire ONLY inside the FireFinder-XLS enclosure.

5. No wiring used for any of the following can run outside the building:

• a DLC loop

• an RS-485 network

• a NAC circuit used for audibles, audio, and telephone risers

• an HZM initiating device zone

For additional wiring

information, refer to this

manual or call Siemens

Building Technologies,

Inc. Technical Support

Department at

1-800-248-7976.

1 2 3 4 5 6 7 ... 71 72

Nessun commento

Siemens FIREFINDER-XLS Manuale di Avvio Rapido Pagina 2