Siemens EF 83P Series Manuale delle Istruzioni Scaricare il pdf (Pagina 107)

9-1

9. Maintenance

9.1 Maintenance of the Limit Switch on X Axis

9.1.1 Select the MPG mode and X axis which on the control panel.

9.1.2 Adjust the X axis home position.

Move the X axis toward to positive direction until the limit

switch touch inside the home dog of the X axis 9-10mm, as

shown in the below drawing. Now the 0 series diagnosis No.

16 bit 5(18 series:X1009 bit 0) interchange 1 into 0. If it

doesn’t interchange to 0, please adjust the switch till touch

the home dog and the number is changed to 0.

9.1.3 Move the X axis continuously and toward to positive

direction when the 0 series diagnosis number 16 bit 5(18

series:X1009 bit 0) display 0. Then, move again the X axis

until the 0 series diagnosis No. 16 bit 5(18 series:X1009 bit 0)

change 0 into 1. Now the limit switch to away and not touch

the home dog.

9.1.4 Please move X axis again. When the limit switch touch the

emergency dog, the 0 series diagnosis No. 21 bit 4(18

series:X1008 bit 0) change 1 into 0 and jump to

MDI

mode

on control panel. The screen will display “

NOT READY

”

message.

9.1.5 Press the

EMG.

release button. Now, move the X axis toward

to negative direction and the limit switch go away the dog.

Check the 0 series diagnosis No. 16 bit 5 (18 series:X1009 bit

0) and 0 series 21 bit 4(18 series:X1008 bit 0) to display 1.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 113

Nessun commento

Siemens EF 83P Series Manuale delle Istruzioni Pagina 107